-6-
(4) Removal of the slip clutch ass’y
(a) Use a bearing puller to remove the Ball
Bearing 629VV
[138] {148}
.
(b) Use an adequate sleeve-like cradle to
support Washer (A)
[132] {142}
as shown
below. Use a hand press to press the Bevel
Pinion
[127] {137}
on the Spacer
[137] {147}
side. Detach the Gear Holder
[133] {143}
and Spacer
[137] {147}
from the Bevel
Pinion
[127] {137}
.
(c) When removing the Second Gear
[136] {146}
from the Gear Holder
[133] {143}
, put these
parts in a plastic bag and disassemble in the
bag to avoid losing Spring (C)
[135] {145}
and the Needle Pin D6 x 6
[134] {144}
.
3. Disassembly of the motor
(1) Firmly hold the Housing
<55>
and use a plastic
hammer to tap the shaft of the Rotor
<62>
until
the spigot joint of the Gear Cover
[145] {155}
is
removed from the Housing
<55>
.
(2) The Rotor
<62>
has strong magnetic force.
Firmly hold the Housing
<55>
and pull out the
Gear Cover
[145] {155}
from the Housing
<55>
.
NOTE: When the Gear Cover [145] {155} is
separated from the Rotor <62> and
the Rotor <62> remains in the
Housing <55>, press the Housing
<55> and push the shaft section of
the Rotor <62> to remove the motor.
Tap the shaft of the Rotor
<62>
.
• Removal of the slip clutch
[138]{148}
Adequate cradle
[132]{142}
[136]{146}
[127]{137}
[137]{147}
[133]{143}
[135]{145}
Hand press
[134]{144}
• Disassembly of motor
[145] {155}
<55>
<62>
