-13-
(d) Pass the three connectors of the Controller Ass’y
<63>
through the lower window of the Back Cover
<87>
, and then insert the connectors into those of On Lock PCB (A) Ass’y
<92>
.
NOTE: Do not insert the connectors in the wrong direction.
(e) Insert the three connectors of On Lock PCB (B)
[109] {111}
into the connectors of the Controller
Ass’y
<63>
.
NOTE: Do not insert the connectors in the wrong direction.
(3) Wiring of the filter PCB set (See the figure on page 15.)
(a) Pass the two terminal-attached internal wires of the Controller Ass’y
<63>
through the lower window
of the Back Cover
<87>
, and then connect the internal wires with the two terminal-attached internal
wires of the Filter PCB Ass’y
<71>
.
NOTE: Connect the crimp-type terminals with those of the same colors. Insert the terminals
all the way in.
(b) Connect the two core-exposed internal wires of the Filter PCB Ass’y
<71>
with Pillar Terminal (A)
<81>
.
(4) Wiring of the switch (See the figure on page 15.)
Pass one core-exposed internal wire of the Controller Ass’y
<63>
through the window of the Back Cover
<87>
, and then connect it with the terminal No. 2 or 3 of the Switch
<77>
.
Connect one core-exposed internal wire of On Lock PCB (A) Ass’y
<92>
with the terminal No. 2 or 3 of
the Switch
<77>
(whichever is not connected).
NOTE: The internal wires are connectable with either terminal.
(5) Wiring of the cord (See the figure on page 15.)
Connect the core-exposed internal wires of the Cord
<85>
to Pillar Terminal (A)
<81>
.
NOTE: The internal wires are connectable with either terminal.
(6) Mounting the back cover
(a) Attach the Dust Seal
<56>
and Packing (B)
<57>
to the Tail Cover
<58>
and mount it to the Housing
<55>
. Then fix it with the Bolts M5 x 14
<59>
.
(b) Insert the two shafts on top of the Housing
<55>
into the two holes of the Controller Ass’y
<63>
.
Pass the internal wire of On Lock PCB (B)
[109] {111}
through the notch at the rear of the Panel
Ass’y
<67>
, and then insert the two shafts on top of the Housing
<55>
into the two holes of the Panel
Ass’y
<67>
.
(c) Mount the Back Cover
<87>
without getting the internal wires caught and fix it to the Housing
<55>
with four Bolts M5 x 16
<88>
. Then fix it to the Crank Case
[125] {135}
with two Bolts M5 x 14
<59>
.
