III. OPERATING FEATURES OF THE VACUUM CLEANER
HITACHI CV-710
This cleaner incorporates the following features:
• dust bag full indicator
• reusable cloth bag
• four micro-filters (one inlet and three exhaust)
• carrying grip
• electronic speed control
• telescopic tubes
• optional double paper bag
PB4
IV. PREPARING THE VACUUM CLEANER FOR USE
Assemble the cleaner accessory parts as shown in figures 5,6 and 7. NB. To use the
dusting brush (figure 3), slide the upholstery nozzle (figure 2) into the slots on the back
of the dusting brush.
Fully extend the power cord and plug from the appliance to the mains. The cleaner can be
switched ON/OFF with the button showing
I/O
(figure 8) The suction force can be altered
by turning the suction control on the suction hose (figure 9) and by the slide control
(figure 10). After you have finished cleaning, unplug the cleaner from the mains. To retract
the mains cord into the body of the cleaner, first hold the power plug in your hand then
press the button showing a plug (figure 11).
CAUTION: the power plug must be held when retracting the power cord to prevent
injury due to whiplash etc.
The cleaner can be held and carried by the carrying grips in the cleaner body (figure 27).
The cleaning accessories can be either disassembled or left assembled and hooked
on the cleaner side or bottom in the standby position (figures 28 & 29).
Full-bag indicator
Check the cleaning power by lifting the floor nozzle from the surface (with the power set to
maximum) and the suction control on the hose closed. Should the indicator light, the dust
bag must be replaced (figure 12).
Replacing the dust bag
After depressing the lid lock in the front of the lid (figure 13) , lift the lid to the open position
(figure 14). Remove the holder carrying the dust bag (figure 15). Remove the dust bag
from the dust bag holder by pulling the catch (figures 16a & 16b). Replace the dust bag in
the dust bag holder. Its curved edge with the recess in the dust bag face should fit against
the slot in the dust bag holder, so that the dust bag catch is engaged (figure 17). Following
the above dust bag removal procedure in the reverse order, install the dust bag holder
carrying the dust bag into the cleaner compartment and close the lid.
Important:
The safety catch (figure 20) does not allow the cleaner lid to be shut as long as there is no
paper bag installed.
Exchanging micro-filters
5
