Usually after five paper bags have been filled, the micro-filters must be exchanged for new
ones. To exchange the intake micro-filter, pull the grill holding the micro-filter upwards from
the dust bag compartment (figure 21). Open the grill cartridge and exchange the micro-filter
(figure 22). To exchange the exhaust micro-filters, press the lock in the cleaner grille
bottom, lift the grille and remove it from the cleaner (figure 23). Remove the filter cartridge
with the micro-filters (figure 24) and replace the filters with new ones (figure 25).
WARNING: Failure to replace the micro-filters regularly can result in cleaner
damage!
Please ensure that replacement micro-filters are installed as detailed
below:
Pre-motor micro-filter:
The pre-motor micro-filter must be installed so that its green side
faces the cleaner compartment.
Reusable cloth dust bag
A reusable cloth dust bag is supplied as standard accessory. The cloth dust bag is
removed and reinstalled in exactly the same way as the paper dust bag.
To empty the dust bag, proceed as follows:
1. Remove the bag from the holder and the clamp bar by pulling to the side (Figure 30).
The cloth bag can be opened and the dust shaken and emptied. (Figure 31).
2. Reinstall the clamp bar by following the above procedure in the reverse order. Put the
bag back in its holder and install the bag and the holder in the cleaner.
Important precautions:
- never wash or dip the cloth dust bag in water
- never use a damaged cloth dust bag
- the safety catch (Figure 20) will not allow the cleaner lid to shut if no dust bag
(paper or cloth) has been installed
Exhaust micro-filter:
The exhaust micro-filter must be installed in the grille cartridge, so
that green part of the element is visible from the grille. The second
green/white element should be installed behind the first green/white
element and the black carbon element should be installed behind
the two green/white elements. (The sequence of the filter elements
is as follows: grille, green/white, green/white, black carbon.)
Storing the cleaning accessories
The upholstery, crevice tools and brush can be stored in the storage compartment of the
cleaner under a separate lid (figure 26).
V. MAINTENANCE
Store the cleaner in a dry place and protect it from any heat source. Protect the cleaner
from exposure to the elements such as rain or sunshine. Clean the appliance surface with
a damp soft cloth and never use abrasive or corrosive cleaners.
6
