Hitachi CV-600, Service Manualv

Page: 3 / 15

3
To reassemble, insert the projection on the flap into the top case and
clip the ‘U’ pieces on to the projections opposite the retaining clips.
Press down the flap until a click is heard.
2.2 Dismantling and Reassembling the Lid
Dismantle the panel as described above, remove the hinge pins, then
remove the top accessory lid followed by the dust compartment lid by
sliding it out
To reassemble, put the dust compartment lid together with the top
accessory lid in the hinge plates , insert the hinge pins, then replace
the panel.
2.3 Removing and Replacing the Switch
Dismantle the panel and the switch flap, then press the clip under the
switch and slide it out from the plate.
To replace, push the switch into the plate.
2.4 Removing the Control Board
Dismantle the panel, take out the control board from the slots and
remove
all the connections (noting the position of each connector). To
replace, follow the reverse procedure
.
ATTENTION! When
reassembling, the potentiometer slider and the control knob must be
placed in the same extreme position to fit together.
2.5 Dismantling and Reassembling the Cover
Remove the grille, panel, control board and the two lids . Unscrew six
screws
,
remove the switch and its connectors. Pull out a short piece of
the supply lead, ( use a screwdriver to remove the outlet cover if
necessary), remove the clip on top of the outlet cover and pass the
supply lead through the outlet and cover, then remove the cover.
To reassemble, pass the supply lead through the cover aperture and
outlet. Pass the motor and winder conductors through the cover
aperture (also reconnect the small cooling hose). Then put the cover
on the casing so that both pressings should fit in well together. Press
the trim in the front, between both pressings and screw on the cover.
Then click the outlet into the cover. Refit the power plug.