--- 19 ---
Fig. 11-a
2. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, particular
attention should be given to the following items.
(1) Mounting Second Shaft (B) [30] to the Recipro Plate [27] (Fig. 11)
Use the special jigs (J-330 and J-315) for press-fitting.
First, mount two Ball Bearings 6003VVCMPS2L [28] and the Retaining Ring for D35 Hole [29] to the Recipro
Plate [27] to make an assembly of the Recipro Plate [27].
(a) When Gear (B) [31] and Ball Bearing 608VVC2PS2L [32] are not mounted:
Mount the assembly of the Recipro Plate [27] to the jigs as shown in Fig. 11-a and push it in the arrow
direction with a press.
(b) When Gear (B) [31] and Ball Bearing 608VVC2PS2L [32] are mounted:
Mount the assembly of the Recipro Plate [27] to the jigs as shown in Fig. 11-b and push it in the arrow
direction with a press. Be careful of the direction when press-fitting the assembly of the Recipro Plate
[27].
J-330
J-315
Fig. 11-b
[28]
[27]
[32]
[28]
[27]
[31]
[29]
[29]
Summary of Contents for CR 13VC
Page 34: ......