Hitachi CP-X1200W, Service Manual

Page: 32 / 97

30
CP-X1200(P5XLA) / CP-X1250(P5XMLA) / CP-X1200
W
A(P5XMLB)
/ PJ1165(P5XMB)
Squeeze the CNPWR cables into the left hand side of the
power block before connecting the power air intake fan,
also make sure that the CNBAR cables have been passed
through the ballast holder slots.
Power board
Ballast board
CNPWR
Connect the CNPWR to the CN1
connector, and make sure that it
is perfectly locked.
(b) Wiring of the ballast board when it is placed on top of the power board.
(3) Wiring of the power board block (for assembling the board block sub assembly)
(a) Wiring of the ballast block before it is placed on top of the power board.
Power board
Ballast board
Make sure that the CNBAR
does not droop on top of the
ballast board.
(Maintain a safe distance.)
(Prevents the CNBAR from
coming into contact with the
fan blades.)
Make sure that the lines do
not protrude from the notch
of the ballast cover.
(Prevents tangling.)
Pull the CNPWR cables to the left (in the direction of the arrow in the
diagram below), when placing the ballast board on top of the power board.
(The cables may come into contact with the spinning blades of the power
air intake fan to the right.)
(c) Outline of the ballast board after it has been placed on top of the power board.
CNBAR
Power air intake fan
#3054
CNBAR
Lamp
leads
Run the lamp leads in the power
block's grooves.
#3054
leads
CNBAR
CNTH
Connect the CNTH cable to
the E950 sensor board's
connector.
CN1
Wiring diagram 2 (P5XLA/P5XMLA/P5XMLB)