( C o n t i n u e d )
CAUTION for 200 240V operation only
This equipment relies on the protective devices in the building installation for
short-circuit and over-current protection. Refer to the following table for the suitable
number and location of the protective devices which should be provided in the building
installation.
Informative examples of
protective devides
in
single phase equipment or sub assemblies
Protection Minimum number
Location
a g a i n s t
of fuses or circuit
breaker poles
Case A:
Equipment to be Earth faults
1
Phase conductor
connected to POWER SYSTEMS Overcurrent
1
Either of the two
with earthed neutral reliably
c o n d u c t o r s
identified, except for Case C
below.
Case B:
Equipment to be Earth faults
2
Both conductors
connected to any
Overcurrent
1
Either of the two
including IT POWER SYSTEMS
c o n d u c t o r s
and supplies with reversible
plugs, except for Case C below.
Case C:
Equipment to be Earth faults
2
Each phase
r
connected to 3-wire power Overcurrent
2
systems with earthed neutral
Each phase
r
reliably identified.
I
Verify that the protective devices in the building installation meets the conditions in the
table prior to installing the equipment.
Be careful of static electricity on CRT surface !
To prevent electrical shock by the static electricity on the CRT surface, disconnect the
power cord at least 30 seconds after turning OFF the power.
Avoid frequent power ON-OFF switching !
Do not repeat OFF and ON power switching in a short period.
This may cause blurred
colours or distortion of the displayed pattern.
Be careful of generated magnetism
After the power has been turned ON or when the degauss function has been manually
engaged, the CRT is demagnetised for approximately 7 seconds. This generates a
strong magnetic field around the front cover which may affect the data stored on
magnetic tape or disks near the front cover.
Place such magnetic recording equipment
and tapes/disks away from this unit.
About cleaning
Before cleaning, turn OFF the power switch and disconnect the plug from the power outlet.
For the screen, use water with a lightly moistened soft cloth such as a gauze type material.
For the cover, use water or a liquid synthetic detergent, with a lightly moistened soft cloth.
Do not clean the
of monitor by yourself as it is very dangerous.
Refer to your dealer.
Do not use aerosol sprays, solvents or abrasive cleaners.
l - 4
