13
English
carry out pocket cutting quite easily with the saw
blade installed in reverse as illustrated in
Fig. 23
,
Fig. 25
, and
Fig. 27
. Use the saw blade that is as
short and thick as possible.
(1) Press the lower part (or the upper part) of the base
against the material. Pull the switch trigger while
keeping the tip of the saw blade apart from the
material (
Fig. 22
,
Fig. 23
).
(2) Raise the handle slowly and cut in with the saw
blade little by little (
Fig. 24
,
Fig. 25
).
(3) Hold the body firmly until the saw blade completely
cuts into the material (
Fig. 26
,
Fig. 27
).
CAUTION
䡬
Avoid plunge cutting for metallic materials. This can
easily damage the blade.
䡬
Never pull the switch trigger while the tip of the
saw blade is pressed against the material. If you
do so, the blade can easily be damaged when it
collides with the material.
䡬
Make absolutely sure that you cut slowly while
holding the body firmly. If you apply any
unreasonable force to the saw blade during the
cutting operation, the blade can easily be damaged.
NOTE
The use of the battery BCL1015 in a cold condition
(below 0 degree Centigrade) can sometimes result
in the weakened cutting torque and reduced amount
of work. This, however, is a temporary phenomenon,
and returns to normal when the battery warms up.
6. Battery Level Warning Lamp
The battery level can be checked by pulling the
trigger switch while the power tool is in a no-load
state. The battery level warning lamp lights when
the battery power is very low. If this happens,
charge the battery. (
Fig. 5
)
NOTE
䡬
The level at which the battery level warning lamp
lights may vary due to the ambient temperature,
characteristics of the battery, etc. and is intended
only as a guide.
䡬
The battery level warning lamp may light when the
power tool is overloaded. This does not mean that
the battery power is very low.
Be sure to check the battery level while the tool
is in a no-load state.
01Eng_CJ10DL_EE
7/24/09, 17:46
13
