Hitachi CG22EJ, Owner'S Manual

Page: 9 / 98

GB-8
Fig. 1-8 Fig. 1-8B
Installation of blade guard
(Fig. 1-8, 8B, 8C, 8D)
NOTE !
The guard bracket may come already mounted
to the gear case on some models.
Install the blade guard on drive shaft tube against
angle transmission (2) / gear case (1). Tighten
the guard bracket firmly so that the blade guard
does not swing or move down during operation.
Unscrew the locating screw (1), and set and
tighten the guard bracket with the locating screw,
then install the blade guard on drive shaft tube.
CAUTION!
Do not attempt to install metal blade on the
curved shaft trimmer. It is very dangerous.
CAUTION! (Fig. 1-8B)
Some blade guards are equipped with sharp line
limiters. Be careful with handling it.
Fig. 1-4 Fig. 1-5
Fig. 1-7 Fig. 1-6
Throttle wire / stop cord
Remove air cleaner cover. (Fig. 1-4)
Connect stop cords. (Fig. 1-5)
Set outer-receiver (1) (If so provided) into wire
guide and put throttle wire through the outer-
receiver. (Fig.1-4)
Connect throttle wire end to carburetor and
install swivel cap (2) (if so equipped) where is
included in tool bag, onto swivel (Fig. 1-6)
Cover throttle wire and stop cords together with
protective tube provided up to air cleaner cover.
(Fig. 1-7)
Fig. 1-8C
1
2