Hitachi CB6Y, Instruction Manual

Page: 17 / 60

English
– 17 –
GENERAL MAINTENANCE
• For your own safety, turn switch OFF and remove the
plug from power source receptacle before maintaining,
cleaning, adjusting, or lubricating your band saw.
• To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the band saw.
• To avoid eye injury from blowing debris, wear safety
goggles when blowing out sawdust.
BAND SAW
Sawdust will accumulate under the table and base. This could
cause difficulty in the movement of the body when setting up
a band saw cut, and also cause a fire hazard.
Frequently blow out or vacuum up the sawdust.
Keep your band saw clean. Remove the sawdust from the
inside. Vacuum or blow out frequently.
Do not allow filth to build up on the table, the guides, or the
support bearings. Clean them with gum and pitch remover.
NOTE: Do not immerse the support bearing in the gum and
pitch remover.
Put a thin coat of paste wax on the table so that the wood
slides easily while cutting.
BLADE WHEEL TIRES
Pitch and sawdust that build up on the tires, should be
removed with a stiff brush or scraped off with a piece of
wood.
NOTE: To avoid damaging the tires, do not use a sharp knife
or any kind of solvent.
When the tires become worn they should be replaced. When
replacing the tires, stretch them around the wheels but do
not glue them on.
MOTOR
Frequently blow or vacuum out any sawdust from the motor.
To avoid electrocution or fire, immediately replace a worn,
cut or damaged power cord.
LUBRICATION
All of the bearings are packed with grease at the factory.
They require no further lubrication.
BATTERIES
Check the batteries regularly to avoid deterioration. Remove
the batteries if you will not be using the worklight for an
extended time.
CAUTION: Never put lubricants on the blade while it is
spinning.
WARNING
WARNING
MAINTENANCE