Identifying rebuild status
After you replaced an HDD, the RAID will be rebuilt automatically. To restore
the RAID subsystem after an HDD replacement, you need to check whether
the RAID rebuild was successful by using Internal Storage Monitor.
If Internal Storage Monitor is not installed in your server blade, you must
install it from the Utility CD-ROM/DVD-ROM in advance.
The basic procedure for identifying the rebuild progress is as follows.
Figure 6-1 Basic procedure for identifying the rebuild progress
In hot-swap (Internal Storage Monitor)
Windows environment
1
.
Click internal storage monitor icon to start the application. When the
icon is not available, click Start > all programs(P) > Server
installation and monitoring tool > internal storage monitor >
internal storage monitor in Windows 2008 server.
2
.
Confirm that internal storage monitor main window is displayed.
3
.
Confirm whether the Fault LED on the replaced HDD is blinking. When the
rebuild is in progress on the HDD, the Fault LED blinks in amber.
6-2
Identifying RAID rebuild status
Hitachi Compute Blade 500 Series System Service Manual
Summary of Contents for CB 520A A1
