Hitachi C28W433N, Instruction Manual

Page: 7 / 32

If language setting is incorrect, use up/down
buttons to highlight LANGUAGE, and select
using the left/right buttons.
Automatic T
Automatic T
uning Procedure
uning Procedure
7 7
Completed Autotune example.
SIGNAL QUALITY - If poor or noisy signals are experienced from your TV during normal operation, fit the supplied
Relay RF cable between your VCR and TV. This measure will improve the picture quality on your TV.
To automatically tune this TV to your local broadcasting stations follow the step by step guide below. Once the TV has found
all your local stations, then they are automatically assigned into the following order:
1.BBC1; 2: BBC2; 3: ITV; 4:CH4/S4C; 5: CH5 (subject to availability); 6: Satellite.
Alternatively, if you are familiar with local broadcasting frequency or CH numbers, then these can be entered manually. Please
refer to the Manual Tuning Procedure section of this booklet.
IMPORTA N T NOTE: If you have a VCR or a Satellite receiver connected to this TV please ensure that they are switched on
before Autotune commences. In the case of a VCR, insert a pre-recorded tape and begin playback of your equipment. With
a Satellite receiver, select SKY NEWS. These measures ensure that all your equipment is tuned in during the AUTO T U N E
procedure. (Satellite equipment installation is explained in the Connecting of External AV Equipment section ).
Note: The VCR programme number should always be set to 0
Highlight INSTALL using the up/down buttons
(if INSTALL is not shown follow step
above once more).
Press the left/right buttons select INSTALL.
The INSTALL menu is shown.
2
3
Use the up/down buttons to highlight
A U TOTUNE.
Use the left/right buttons to begin
A U TOTUNE.
4
5
6
Press and H O L D the MENU button until Main
Menu with INSTALL is shown
1