Hitachi C 10RA, Technical Data And Service Manual

Page: 29 / 52

--- 25 ---
(1) Remove the M6 x 60 Bolt [14] and M6 x 35 Bolt [21] using a 10 mm wrench, and remove the Saw Blade
Guard and Spreader Assembly (Blade Guard [7] and Spreader [23]). (For the U.S.A., Australia and New
Zealand)
Remove the M6 x 16 Bolt [174] with the hex. wrench, then remove the Saw Blade Guard and Splitter
Assembly (the Blade Guard [176] and [177] and the Splitter [172]). (For Europe)
(2) Remove the two M5 x 8 Machine Screws [20] and remove the Table Insert [19]. (For the U.S.A., Australia and
New Zealand)
Remove the two M5 x 16 Flat Hd. Screws [20] and remove the Insert [19]. (For Europe)
(3) Put the 22 mm Wrench (standard accessory) on the Spindle Ass'y [201] to hold it. Then, put the 23 mm end of
the 23 x 26 mm Wrench (standard accessory) on the Set Nut [76]. Turn it counterclockwise to remove the nut,
and remove Washer (A) [75], the TCT Saw Blade [704] and Washer (A) [75] in this order.
Refer to Fig. 30 for the part numbers of the two-hundred level.
B. Disassembly of the switch section
Tools required:
• Phillips head screwdriver
Fig. 26
(1) Remove the two D5 x 16 Tapping Screws [116] and remove the Switch Mtg. Plate [117]. Then, detach each
lead wire connected to the Circuit Breaker Switch [113] and Rocker Switch [118]. (For the U.S.A., Australia
and New Zealand)
Remove the two D5 x 16 Tapping Screws [116] and remove the Switch Cover [159]. Then, detach each lead
wire connected to the Circuit Breaker Switch [160], Electro Magnetic Disturbance [152] and NVR-Switch
[161]. Remove the two D5 x 16 Tapping Screws [116] and remove the NVR-Switch. (For Europe)