Hitachi BW-V80FS, User Manual, Page: 9 / 60

9
How to Install the Water Drainage Hose
排水管的安裝（
BW-V80FS
）
1
Lay the unit down slowly.
請將機體輕輕地放倒。
2
Pull out the water drainage hose from the left side of the unit.
排水管從左面引出。
1
Remove the left water drainage hose cover.
將機體左面的排水管蓋拆下。
2
After pulling out the mark of the water drainage hose from the right
groove of the unit, the mark of the water drainage should be inserted into
the corresponding groove of the left unit.
把排水管標記部從機體右側的凹槽內引出，標記部應嵌入機體左側對應的凹槽內。
3
The water drainage hose should be pulled out through the proper hose clamps when the hose is pulled out on the left.
排水管從左面引出時，排水管應通過相應的軟管固定夾後再引出。
■
The water drainage hose is installed at the factory on the right side. It can be moved to the left
side if necessary.
產品出廠時，排水管安裝在機身右側，請視排水位置的具體情況將其換至左側。
Water drainage hose cover
࿢ᖛᾷ╾
Hose clamps
Ⱆᾷߗહप
Mark
ᐻ⥆
Water drainage hose
࿢ᖛᾷ
Water drainage outlet
࿢ᖛם
■
When fi tting the water drainage hose to the
water drainage outlet
排水管插入排水口時
If the water drainage outlet is too shallow
or the end of the water drainage hose
touches the grounds, cut the end of the
water drainage hose in an oblique angle.
排水口較淺或排水管前端與地面碰觸時，可將
排水管的前端沿斜向切除一部分。
•
Failure to do so may cause insuffi cient rinsing or unit
malfunction due to poor
drainage or too much
bubbles during rinsing
and spinning.
若不切除，在沖洗及脫水時，
由於排水狀況的不良，將會
引起沖洗不充分或因肥皂沫
而影響電機運轉。
Attention
注意
The mark of the water drainage hose
should be inserted into the corre-
sponding groove of the unit.
安裝洗衣機時，請務必將排水管的標
記部嵌入機體相對應的凹槽內。
• Water drainage hose which inserts into the unit,
cannot touch other parts, to prevent the damage
caused by water leakage.
排水管在機體內的部分，不應與其它部件碰觸，以
免因破損產生漏水而導致不必要的損失。
• Water drainage hose clamp must be tightened.
排水管固定夾必須夾緊。
• The inner section of the water drainage hose must be
secured by the clamp before being fetched out.
排水管機內部分必須經固定夾固定後再引出。
•
Lay the unit down on some corrugate paper to prevent damage.
放倒機體時，請在地面上放置一些瓦楞紙類的襯墊，以免損傷機身。