Hitachi BD-D100GV, Instruction Manual

Page: 13 / 72

13
●
The symbol M is for checking whether you install the washer dryer correctly.
M Make sure that the union nut between the water supply hose and main unit is tightly screwed.
M
Turn the tap on to check if the water supply hose is properly connected before starting. If it is loosely
connected, water leakage may occur.
●
Drain hose
M
The drain hose should be placed higher than 60 cm above and not higher than 100 cm above the fl oor.
If the drain outlet is lower than 60 cm, a joint pipe is
necessary (additional part, sold at a specialist outlet).
Secure the drain hose to prevent from slipping out from
joint pipe.
60~100 cm
Joint pipe
M Do not bend, twist, crush or pull out, bend or step on the drain hose. Use the hose guide to prevent the
drain hose from kinking.
M Do not detach the drain hose from the rear panel of the washer dryer.
Drainage into a wash basin (Using the packed-in hose guide) :
– Secure the drain hose to prevent it from slipping out of the wash
basin.
– The wash basin outlet must not be sealed by a plug.
– When water is being pumped out of the washer dryer, check that
the water drains away quickly enough.
Drainage into a siphon :
– Secure the connection point with 24-40 mm φ hose clip
(Sold at a specialist outlet).