Hitachi B 16RM, Safety And Instruction Manual

Page: 3 / 64

— 3 —
English
WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals
known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals, work in a well-ventilated area and work with approved safety equipment such as dust masks that are
specially designed to filter out microscopic particles.
PRODUCT SPECIFICATIONS
Chuck Size ......................... 5/8"
Speed ................................ 12 (250 ~ 3,100 min
–1 )
Motor ................................. 120V, 60 Hz, 8 Amps
Horsepower ...................... 1 HP (Max. Developed)
Built-in Light ..................... 60 Watt (Maximum)
(Bulb not included)
Table Size .......................... 13-15/64" x 13-15/64"
Table Tilt ........................... 45° Right or Left
Spindle Travel ................... 3-1/8"
Throat ................................ 7-1/2"
Base Size ........................... 11" x 20-3/8"
Height ................................ 63-1/4"
NET WEIGHT ..................... 156.5 LB (71.0 kg)
WARNING
To avoid electrical hazards, fire hazards, or damage to the
tool, use proper circuit protection.
Your drill press is wired at the factory for 120V operation.
Connect to a 120V, 15 AMP branch circuit and use a 15
AMP time delay fuse or circuit breaker. To avoid shock or
fire, replace power cord immediately if it is worn, cut or
damaged in any way.