5
2.2.2 RF Communication Check (Test Mode)
To check the RF communication, hold the
Room Unit
about 2-3 metres from the installed
RF Receiver
.
Set the
Room Unit
to off by pressing the button. then press the and buttons together with the
button for 3 seconds. The unit will displa
y ‘
tESt
’
and it will send test signals to the
RF Receiver
. If
the test signals are received the LED on the
RF Receiver
will flash between 1 and 5 times. The number
of flashes indicates the strength of the radio signal. The higher the number of flashes, the stronger the
signal is.
NOTE:
If the LED does not flash or if you are installing a replacement
RF Receiver
or
Room Unit
, follow
the procedures described in section
4. Binding / Rebinding Procedure
.
2.2 Installing the Room Unit
2.2.1 Power Up
Installing the Batteries:
a.
Lift up the front cover of the
Room Unit
to reveal the battery cover and product controls.
b.
Remove the battery cover by pressing down and sliding out.
c.
Insert the 2 x AA LR6 Alkaline Batteries supplied with the
Room Unit
, ensuring the correct orientation.
d.
After a short pause the
Room Unit
will display information on the screen and is now ready for use.
e
. Replace the battery cover by sliding it firmly back into the front of the
Room Unit
.
Setting the Date and Time:
a.
Press the button to begin setting the date. When you set the date for the
first time after the batteries are inserted, the display will show:
Press the or buttons to set the current day of the month (e.g.
d 01
=
1
st
day of the month) then press the green
button to confirm.
b.
Press the or buttons to set the current month of the year (e.g.
m 01
= January) then press the green
button to confirm.
c.
Press the or buttons to set the current year (e.g.
yr 09
= 2009) then
press the green
button to confirm.
The date is now stored and the Day Indicator will be displayed under the
current day of the week (e.g. 1 = Monday, 2 = Tuesday, etc.)
d.
Use the or buttons to set the correct time then press the green
button to confirm. Each press of the buttons will change the time by one
minute and holding them down will change the time slowly at first and get
progressively quicker.
Note:
If this mode is entered accidentally then press the
,
or
buttons to exit.
AM
Installation and Operation Manual
ΕΛΛΗΝΙΚΆ SVENSKA
NEDERLANDS DANSK POR
TUGUÊS IT
ALIANO FRANÇAIS DEUTSCH ESP
AÑOL
ENGLISH
Summary of Contents for ATW-RTU-02
Page 112: ...PMML0213 rev 0 11 2010 ...
