Hitachi 42HDT52, Operating Manual

Page: 37 / 104

Operating the precoded function for your
VCR/PVR (Personal Video Recorder).
This remote is designed to operate different types of
VCRs/PVRs. You must first program the remote to
match the remote system of your VCR/PVR (refer to
pages 40-41 for pre-codes).
1. Turn ON your VCR/PVR.
2. Aim the remote control at the front of your
VCR/PVR.
3. To switch to VCR/PVR pre-coded mode, use the
SOURCE ACCESS buttons ( , ) on the remote
control to position the LED light to the
corresponding selection.
4. Hold down the ENT button on the remote and enter
the four digit preset code that matches your
VCR/PVR, as shown on pages 40-41. Release the
ENT button. The indicator light will flash 3 times if
the code was accepted.
5. Aim the remote at the VCR/PVR and press the
POWER button. The remote will turn off your PVR
when the correct four digit preset code is entered.
When this occurs, the remote control is
programmed for your VCR/PVR. If the VCR/PVR
does not turn off, try a different four digit preset
code.
6. The remote will now control your VCR/PVR.
NOTE: 1. If your VCR/PVR cannot be operated after
performing the above procedures, your
VCR/PVR code has not been precoded
into the remote.
2. In the unlikely event that your VCR/PVR
cannot be operated after performing the
above procedures, please consult your
VCR/PVR operating guide.
3. The remote control will remember the
codes you have programmed until the
batteries are removed from the from the
remote control. After replacing the
batteries repeat the entire programming
procedure as stated above.
PRECODED VCR/PVR Buttons
These buttons transmit the chosen precoded
VCR/PVR codes.
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
MY VCR/PVR CODE IS:
NOTE: Refer to instruction manual of the VCR/PVR
for operation of the buttons exclusively for
the VCR/PVR.
The Remote Contr
o
l
37
The Remote for VCR/PVR Functions
/