5
4
Quick Start Guide
ENGLISH
To switch the TV on
(Depending on the model)
Starting Auto Setup Procedure
Note:
Do not turn off the TV while initializing first time installation.
When the TV is operated for the first time, installation wizard will guide
you through the process. First, language selection screen will be
displayed.
After then, “
First time Installation
” menu will appear on
the screen, requiring you to set Country,Teletext Language, Scan
Encrypted and Active Antenna (optional) options:
After setting the options using the navigation buttons press
OK
button
to continue. The following message appears on the screen:
To start automatic search, select “
Yes
”, to cancel, select “
No
” and
press
OK
button. Afterwards, digital search type OSD will be
displayed on the screen.
If you select
CABLE
option, the following screen will be displayed:
By pressing or buttons highlight the language you want to set and
press “
OK
”.
3
2
Insert the batteries into the handset
Connect the aerial straight to your TV
Connect the TV to the mains socket
1
Insert two
AAA/R3
or equivalent type batteries inside.
Observe the correct polarity (+/-) when inserting batteries and
replace the battery cover.
REAR OF THE TV
Set Top Box
connection
You can select frequency ranges from this screen. For highlighting
lines you see, use
button. You can enter the frequency range
manually by using the numeric buttons on the remote control. Set
Start and Stop Frequency as desired by using numeric buttons on the
remote control.
After this operation, you can set Search Step as 8000 KHz or 1000
KHz. If you select 1000 KHz, the Tv will perform search process in a
detailed way. Searching duration will thus increase accordingly. When
finished, press
OK
button to start automatic search.
If you select
AERIAL
option from the Search Type screen, the
television will search for digital terrestrial TV broadcasts.
Note:
You can press MENU button to cancel.
After all the available stations are stored, Channel List will be
displayed on the screen. If you like the sort channels, according to the
LCN, please select
Yes
and than press
OK
. Press
OK
button to quit
channel list and watch TV.
or
To select the HDMI input, press the “
SOURCE
” button on the remote
control. Each time it is pressed the on-screen menu confirms your
selection.
To HDMI connection on the device
6
HDMI to HDMI Cable Connection
7
HDMI input
insert plug...
•
•
•
•
•
Connect the power cord to the 220-240V AC 50 Hz.
Press STANDBY touch button. Then the standby
LED lights up.
To switch on the TV from standby mode either:
Press the " " button, P+/P- or a numeric button on
the remote control.
Press the -P/CH or P/CH+ touch button on the TV.
The TV will then switch on.
By either method the TV will switch on.
-or-
•
•
•
•
CH
CH
•
, located
on the right
Connect the power cord to the 220-240V AC
50 Hz. Then the standby LED lights up (The
led will blink during the standby On/Off).
To switch on the TV from standby mode either:
Press the " “ button,
or
or a
numeric button on the remote control.
Press the middle of the control switch
side of the TV. The TV will then
switch on.
or
or
RC5100 RC1910
RC1910
RC5100
