Step 12:
Once the rear lift kit plates are secured and tight, make sure the upper shock mounting
bolts are tightened. If you removed the rear wheels you can install them back on at this
point. The rear lift kit is done and now installed.
Step 13:
NOTE: you might have to check the chain adjustment at this point since it might have
moved. Please check and adjust the chain to its proper tension per the service manual.
Also check the chain alignment after adjusting by spinning the rear axle after the chain is
adjusted, and you should not hear any binding on the chain to sprocket.
You are now ready to move on to the front lift kit.
Move to the front of the UTV and again, once the front end is secured safely and off the
ground, you can continue.
Step 1:
Remove the front wheels, this will make it easier for you to install the front lift kit.
Remove the upper and lower front shock bolts and remove the shocks. Keep the bolts
nearby as you will use them again.
