![Hisun Motors HS 244-2 Introduction Manual Download Page 38](http://html1.mh-extra.com/html/hisun-motors/hs-244-2/hs-244-2_introduction-manual_2139337038.webp)
Periodic Service
10-6
■
Checking and Refueling
CAUTION
To avoid personal injury:
Do not smoke while refueling.
Be sure to stop the engine before
refueling.
1. Turn the key switch to “ON”, check the
amount of fuel by the fuel gauge
2. Fill fuel tank when fuel gauge shows1/4 or
less fuel in tank.
①
Fuel tank cap
Fuel tank capacity
28L (7.4
±
0.1U.S.GALS)
IMPORTANT
If oil level is low, do not run engine.
Checking engine oil level
1. Park the vehicle on a flat surface with
engine off, raise the cargo bed, mount the
safety support.
2. To check the oil level, draw out the dipstick,
wipe it clean, replace it, and draw it out
again, check to see if the level is too low,
add new oil to the prescribed level on the
dipstick.
①
Oil Level
②
Dipstick
■
Checking Coolant Level
CAUTION
TO avoid personal injury
Do not remove radiator cap while coolant
is hot .when cool .slowly rotate to the
first stop and allow sufficient time for
excess pressure to escape removing the
cap completely.
1. Park the vehicle on a flat surface, access the
panel under the hood, set the parking brake, and
shut off the engine.
2. Check to see that the coolant level is
between the “FULL” and” LOW” marks of
recovery tank.
3. When the coolant level drops due to
evaporation, add water only up to the full level.
In case of leakage add anti-freeze and water in
the specified mixing ratio up to the full level.(see
flush cooling system and changing coolant in
EVERY 2 YEARS in PERIODIC SERVICE
section)