HISON WATERCRAFT
7
To start the engine:
1.
Insert the key in the ignition switch and turn the key to the ON position. A buzzer will briefly
sound to indicate that the ignition is ON.
2.
Check that the steering column lock has disengaged by moving the handlebars from left to
right.
3.
Make sure the engine safety cut-off is inserted under the engine off button and that the
lanyard is secured to your wrist or your personal flotation device (PFD). If the rider falls off
the Crosski, the engine will stop when the safety cut-off is removed.
4.
Make sure the throttle lever is not pressed.
5.
When on land, apply and hold the brake levers.
6.
Press and hold the engine start button until the engine is running.
7.
Release the start button once the engine has started.
△
!
WARNING
When the engine is started, gear 1 is automatically selected. Do not rev the engine when
the Crosski is stationary.
The het impeller runs whenever the engine speed exceeds 2000 rpm irrespective of
whether the Crosski is on land or water. Keep others away from the intake grate and jet
nozzle when the engine is running.
Note
: In cold conditions, the engine start time will increase.
Engine Stop/Cut-off
△
!
WARNING
To maintain directional control on water, the engine must be running.
To stop the engine, press and hold the engine stop button or turn the ignition key to the off
position.
Alternatively, if the engine safety cut-off is pulled from under the engine stop button, the button
will retract toward the handlebar and the engine will stop.
To reinstall the engine safety cut-off, insert the cut-off between the engine stop button and the
handlebar.
Throttle Lever
The throttle lever on the right handlebar controls the speed of the Crosski when it is being
operated on both land and water.
To increase or maintain the speed of the Crosski Crosski, press on the throttle lever with
your thumb.
To decrease the Crosski’s speed, release the throttle lever.
