Hisense H120RME, User'S Operation Manual

Page: 8 / 51

50-70mm
Sufficient air must be allowed to circulate
in the lower rear section of appliances, as
poor air circulation can affect perfor-
mance.
Appliances must not be exposed to rain.
Sufficient air must be allowed to circulate in
the low rear section of the appliance, as
poor air circulation can affect performance.
Built-in appliances should be positioned
away from heat sources such as heaters
and direct sunlight.
Important!
For this reason,
space should be
available around the . It is
advisable
the back of the to the wall at
least 100mm of space on its two
of over 100mm from its top and a
clear space in front to allow the doors to
open 180°.
It is necessary to have good
ventilation around the refrigerator to allow for
the dissipation of heat, high efficiency, and
low power consumption.
sufficiently cleared
refrigerator
refrigerator
sides, a
height
First use and Installation
Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand new product, then
dry thoroughly.
Important! Do not use detergents or
abrasive powders, as these will damage the
finish.
Installation Positioning
Warning! Before installing, read the
instruction carefully for your safety
and correct operation of the appliance.
Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight etc.
Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.
100mm
100mm
Hisense Refrigerator
Installing the rubber supporting pad
If there is a rubber supporting pad and a
screw provided in a plastic bag with your
a p p l i a n c e , y o u c a n i n s t a l l t h e s e
accessories according to the following
procedure.
Note:
There is no need to install these
accessories under normal usage.
Only under the extreme circumstances,
cabinet empty while load on door with
total mass of 10 kg and opening the door
about 90 degree ,this refrigerator may
take risk of tipping. Then rubber
supporting pad should be fastened to
the lower base cover to steady this
appliance.
8
50-
for there to be separating 70mm