HIS
Business Manufacturing Company
Tel: (619) 447-0009 (800) 292-9831 Fax: (619) 447-4695
Web Site: www.hizbiz.com Email: [email protected]
4
General Safety Instructions
HIS Cable Puller
is
designed for productivity
and safety. One person
can easily and efficiently
transport, set up and
pull cable. Always
understand the function
of the cable puller
before operating.
Only
experienced journeymen
should operate cable
pulling equipment.
The cable puller operator should stand off to the side of the puller away
from the line of pull. Always stay clear of the hazard area.
Common Sense, Skill, Safe Working Practices and Caution can help avoid most injuries and keep everyone working!
WARNING! Not intended to be used for pulling live electrical cable
Always read instructions before operating puller
Always inspect puller before operating
1. Inspect cable puller, power lines and surrounding area.
2. Clean up cluttered work area before setting up puller.
3. Inspect cable pulling rope. Rope and eyelet must be in
excellent condition. Use high quality, high grade low
stretch cable pulling rope.
4. Never stand on or near the coiled pulling rope as it lays
on the ground.
5. Always pay close attention to cable pulling. Never let
anyone or anything distract this operation, unless an
emergency situation occurs.
6. Never use in water or in dangerous environments.
7. Think SAFETY, SAFETY, SAFETY!
8. After pull is completed, dismount puller, clean up and
inspect equipment before storing.
Transporting HIS Cable Puller
Before moving the cable puller, inspect
the equipment to make sure that the
extension arms are secured in the
locking position using the locking axle
shafts provided. Check to be sure power
cord and foot switch is contained with
puller and not loose.
When rolling the cable puller steady the
axle using your foot as you lean the unit
back to find it’s natural pivot point at
about waist high or 34”. The unit then
becomes easy to transport in either
direction without exerting undue stress.
When loading and unloading cable
pullers using a hoist, secure one end of
a strap to the handle on the capstan /
motor housing. Loop the other end
through the locking axle shaft
NOTE:
When setting up cable puller and puller arms BE AWARE OF PINCH POINTS
