Hirschmann HiSecOS EAGLE20, User Manual

Page: 30 / 64

30
Installation EAGLE20/30
Release 12 03/2021
The socket housing is electrically connected to the front panel of the device.
The V.24 interface is electrically insulated from the supply voltage.
Figure 1: Pin assignment of the V.24 interface and the DB9 plug
The Terminal cable is available as an accessory.
See “Accessories” on page 60.
1.8.2 SD card interface
Note: For information about the position on the device see “Rear view” on
page 24 .
The SD card interface allows you to connect the AutoConfiguration Adapter
ACA31 storage medium. This is used for saving/loading the configuration
data and diagnostic information, and for loading the software.
The ACA31 supports the FAT16 file system format exclusively.
1.8.3 USB interface
Note: For information about the position on the device see “Front view” on
page 23 .
The USB socket has an interface for the local connection of an
AutoConfiguration Adapter ACA22. It is used for saving/loading the
configuration data and diagnostic information, and for loading the software.
The USB interface has the following properties:
 Supports the USB master mode

Supports USB 2.0 (data rate max. 480 MBit/s)

Connector type A
 Supplies current of max. 500 mA
VT100 terminal settings
Speed 9600 Baud
Data 8 bit
Stopbit 1 bit
Handshake off
Parity none
1
1
8
5
6
2
3
5
1
2
3
4
5
6 CTS
n.c.
TX
GND
RX
RTS
RJ11 DB9 RJ11 DB9