Hioki MR8875, Measurement Manual

Page: 11 / 28

Screen Organization and Operational Overview
9
This explanation applies when using the MR8901 Analog Unit.
Configuring input channels
Waveform screen ( [Channel] window)
[Analog]

Select the channel to configure.
Set the [Range(/div)] .
(Configure other settings as necessary.)
Setting to [Display] allows the Waveform screen
display to be changed. The screen can also be
changed after measurement.
Display [Detail] and configure input module-
specific settings as necessary.
"Configuring triggers (to assign specific conditions for
recording)" (p.10)
2
3
Configure these settings as necessary:
[Filter]
You can set the frequency band to cut (filter
band) if you wish to cut excessive high-fre-
quency components, for example when input
signal noise is a concern.
[Coupling]
The instrument is normally used in DC cou-
pling mode. The zero position can be
checked by setting the instrument to GND
mode.
Open the screen.
[Waveform Display] / [Setting Display]

[Channel]
1
4
3
4
2

To calculate and display input values
Set the display to [Scaling] and set the calculation method.
This functionality allows you to check converted measured
values. It can also be changed after measurement.

To change the waveform color or screen
display
Set the display to [Display] to change the waveform color,
display position, graph settings, display magnification, or
other settings. These settings can also be changed after
measurement.
1