Hioki LR5092, Instruction Manual

Page: 39 / 148

4.1 Collecting Recorded Data of Logger
33
3
4
Chapter 4 Collec
tin
g an
d Br
o
w
sing
Dat
a
When collection is completed, the col-
lected data appears on the display.
The following shows the displayed infor-
mation.
(Channel, comment, data count, record-
ing interval, serial number, recording start
time, recording stop time, maximum
value, minimum value, and average
value)
When the data of a logger which recorded
on two channels is collected, use to
switch channels.
Press the F1 button to switch to waveform
graph display, and F2 button to switch the
numerical value display.
(To return to the previous display, press the
F3
button.)
Waveform Graph Display
Press the F1 button to reduce the wave-
form, and the F2 button to magnify the
waveform.
Use to scroll the waveform.
(To return to the previous display, press the
F3
button.)
Numerical Value Display
Use the F1 and F2 buttons to decimate
the data.
(To return to the previous display, press the
F3
button.)
Waveform Graph Display
Numerical Value Display
Collection Data Display
• In the case of a logger for which data was previously collected (logger
with same serial number), the data is saved to the location where the
previous data was saved. If data exists in both the collector memory
and SD memory card, the save destination becomes the SD memory
card.
• Data can be collected without stopping measurement on the logger.
Data is collected up until the point in time when data collection was
performed. However, the time required to perform data collection is
longer than when measurement is stopped.