Hioki HITESTER 3184, Instruction Manual

Page: 15 / 42

5
―――――――――――――――――――――――――――――――――――――――
Chapter 1 Overview
―――――――――――――――――――――――――――――――――――
CAUTION
The handle can be used as a stand to incline the
instrument. Force should not be applied to the
instrument from above when using it in this manner.
Measurement Terminal Board
The rear panel terminal board is used to connect the
device under test with the power source. Connection
cables should have sufficient capacity ratings, and be
connected securely (and neatly) to avoid accidental short-
circuits.
Fuse Holder
The instrument takes a 0.5 A/250 V arc-quencing, midget
type fuse. Unplug the power cord when changing the
fuse.
AC Inlet
This receptacle is used to connect the instrument to the
AC power supply (AC mains). Use the power cord
provided with the instrument. The power source rating
for your particular instrument is marked in the table
above the fuse holder. Make sure that this rating agrees
with the power source being used.
Handle
As shown in figure on the next page, the handle may be
rotate by sliding the grip at the sides of the handle in the
direction of the SLIDE TO ROTATE arrow.
When the
proper position has been attained, push the slide in the
LOCK arrow direction. The handle may be set at 30
。
detents to fix it in position.