Hioki 9593-03, Instruction Manual

Page: 14 / 66

，
Chapter 4
Operation
4.1 Setting the RS-232C Communication Conditions
• Use the communication condition setting switches on the RS-232C panel to set
the communication conditions.
• On dispatch from the factory, this address is initially set to 00000001 .
Bit
ー
2 3
4
5 6 7 8
Descr
i
pt
i
on Baud rate
Data
length
Par
i
ty
Stop b
i
t Del
i
m
i
ter
BAUD RATE
DATA LENGTH PARITY
Bits Baud rate
1 2
0 0 9600
0 1 4800
1 0 2400
1 1 19200
B
臼言
Bits
Par
i
ty
45
0 0 None
0 1 None
1 0 Even
1 1 Odd
DELIMITER (when send
i
ng)
0: OFF, 1: ON
C三）
• If you change the communication conditions while the 3157 is being used,
then you should immediately turn the power off and on again.
If this is not done, the communication conditions will not be changed to the
new ones.
4. 1 Setting the RS-232C Communication Conditions
• When the 3157 soft start mode is enabled, its operation slows down at starting
test. This may cause a communication error, depending on the preset baud
rate.
•
Bit 8 is fixed at (on) . Switching it will cause improper operation.
Bits 6 Stop bit
0 1 bit
1
2 bit
(Fixed)
"1"
HIOKI 9593C981-01