Hioki 8860-50, Instruction Manual

Page: 91 / 490

79
4
Chapte
r 4
Me
asuremen
t Co
nfiguration Sett
ings
Measurement Configuration
Settings
Chapter 4
1
Open the Settings screen
2
Menu selection
Basic measurement configuration settings are performed on the Status Settings screen. Measurement
configuration can be performed from the Waveform screen (p. 114).
About screen contents:
"2.5.1 Status Settings Screen" (p. 28)
3
Page selection
Function Selection (p. 81)
• Memory Function
• Recorder Function
• REC&MEM Function
Measurement Configuration Settings
• Timebase or Sampling Rate setting (p. 90)
• Recording Length setting (p. 97)
To measure using different sampling rates
• Timebase 1 and Timebase 2 sampling rate
settings (p. 94)
To control sampling by an external signal
input
• External Sampling setting (p. 382)
Set Channels to Use
• Setting the number of channel to use (p. 86)
• Setting different sampling rates (p. 95)
• Setting which channels to use (p. 86)
Utility Function Settings
• View waveforms while acquiring data (Roll
Mode) (p. 102)
• Waveform Overlay (p. 104)
• The number of acquired waveforms and aver-
aging progress (Averaging function) (p. 106)
• Record by memory divisions (p. 109)
(set on the Memory Division Setting screen)
• Real-Time Saving Function (p. 235)
• FFT Function ( Analysis and Communication Supplement )
Memory Function