Hioki 8860-50, Instruction Manual

Page: 40 / 490

2.5 Settings Screen
28
2.5.1 Status Settings Screen
Basic Settings: [Basic] page
Settings for Used Channels: [Use Ch] page
To open the Status Settings screen
Press the
SET
key.
Press the
SUB MENU
keys
1
2
(The Settings screen appears.)
3
Press the
SHEET/PAGE
keys to select a page.
(When using the Memory Function)
to select the menu item.
(Memory Function) [Basic] Page
Timebase or Sampling
Rate Setting (p. 90)
Set the timebase of the hori-
zontal axis (time per division).
The sampling rate changes ac-
cordingly.
Set the timebase (horizontal axis) and recording length (recording duration).
External Sampling
Setting (p. 382)
Select this to control sampling
by means of an external signal
input.
Timebase 2 Settings
(p. 94)
Make these settings to mea-
sure with two sampling rates,
or when using the Model 8958
16-Ch Scanner Unit together
with another input module.
(Memory Function only)
Recording Length
Settings (p. 97)
Set the length (recording dura-
tion) to record each time data
is acquired.
Function Application
Settings
Set as occasion demands.
• Roll Mode (p. 102)
• Overlay (p. 104)
• Averaging (p. 106)
(Memory Function) [Use Ch] Page
Setting Channel Nos to
use
(p. 86)
Select which channel numbers
to use.
Measurement Channel
Settings
Select the analog and logic
channels to use for measuring.
Select the channel or channel numbers to use.
Set when using Timeaxis 2
(p. 95).
Select analog channels to use
for measuring (p. 86).
Select logic channels to use
for measuring (p. 86).
The maximum recording
length is displayed.
Settings can be reset.