INTAKE (J05E)
9–13
MOUNTING THE INTAKE PIPE (EXHAUST SIDE)
1.
MOUNTING THE INTAKE PIPE (EXHAUST SIDE)
(1)
Check the intake system for dirt or foreign matter.
(2)
Wash off oil on the intake hose insertion part and inner side of the
hose inlet.
(3)
Insert the primary intake hose to the turbocharger assembly.
(4)
Tighten the 2 clamps, and mount the primary intake hose to the
turbocharger assembly.
Tightening Torque:
Turbocharger side:
6.25 N·m {64 kgf·cm, 4.6 lbf·ft}
Air cleaner side:
2.4-5.0 N·m {25-50 kgf·cm, 1.8-3.6 lbf·ft}
! CAUTION
No sealing agent must be used at the air inlet and outlet to prevent
defects such as breakage due to clogging or looseness in the
tightening area.
(5)
Replace with a new gasket and mount the secondary intake pipe
to the turbocharger assembly with 4 bolts.
Tightening Torque:
28.5 N·m {291 kgf·cm, 21 lbf·ft}
2.
MOUNTING THE INTERCOOLER HOSE (INLET HOSE)
Reference: COOLING (J05E), INTERCOOLER, OVERHAUL,
MOUNTING THE INTERCOOLER (Page 12-22)
3.
CONNECTING THE HARNESS
(1)
Fasten the engine harness to the secondary intake pipe and pri-
mary intake hose with the clips, and connect the joint connector.
VENTILATOR
HOSE
PRIMARY INTAKE
HOSE
SECONDARY
INTAKE
SHTS021270800018
