X-CPU 01
4 Start-up
HI 801 009 E Rev. 4.00
Page 27 of 52
4 Start-up
To start up the processor module, insert the processor module into a permissible base plate
slot, see Chapter 4.1.1. If the base plate is already operating, the processor module starts
and adopts the operating state set through its configuration and the mode switch position. If
the base plate is not operating, connect the supply voltage.
4.1 Mounting
Observe the following points when installing the processor module:
The module is intended for use within a HIMax base plate. For more information on the
base plate structure, refer to the corresponding system documentation.
Only operate processor modules in the intended slots
Only operate the module with forced cooling (X-FAN).
Only operate the module with the suitable connector board. For more information, see
Chapter 3.6.
Effects of removing and inserting the module:
When removing the module, the connector board remains in the HIMax base plate.
Since all of the external interfaces are connected via the module's connector board, a
module can be replaced without affecting the external interfaces
The SRS of the module is stored to the connector board and becomes after the module
is plugged in.
Effects of pulling and plugging the plugs
Pulling the plugs interrupts the external communication.
Take appropriate grounding measures.
NOTE
Electrostatic discharge!
Failure to comply with these instructions can destroy the connector board and/or the
module.
Make sure that the workspace is free of static and wear an ESD wrist strap.
If not used, ensure that the device is protected from electrostatic discharge, e.g.,
by storing it in its packaging.
Effects of EMC influences
Exposing the module to environmental influences other than those specified in the
manual may lead to malfunctions or even the destruction of the module.
NOTE
Controller damage or system malfunction possible!
Only expose the module to permissible environmental influences, see Chapter 2.1.1
Summary of Contents for HIMax X-CPU 01
Page 1: ...X CPU 01 HIMax Manual...
