4 Start-up
X-CPU 01
Page 28 of 52
HI 801 009 E Rev. 4.00
4.1.1
Slots Permitted for the Processor Module
The following rules must be observed when assigning the slots to the processor modules,
also in the Hardware Editor:
1. A maximum of four processor modules may be used.
2. Processor modules may only be inserted in the following slots:
-
Slots 3 to 6 on rack 0.
-
Slots 3 to 4 on rack 1.
3. Slot 5 on Rack 0 and Slot 4 on Rack 1 may not simultaneously contain processor
modules..
4. Slot 6 on Rack 0 and Slot 3 on Rack 1 may not simultaneously contain processor
modules..
NOTE
System malfunction possible!
Only slots complying with these rules may be used for processor modules.
The table specified the recommended variants complying with the rules:
Variant
Base plate 0
Processor module(s) in slot:
Rack 1
Processor module(s) in slot:
Required
system
busses
1
3 for mono operation
1)
-
A
2
3
-
A + B
3
3, 4
-
A + B
4
3, 4, 5
-
A + B
5
3, 4, 5, 6
-
A + B
6
3
3
A + B
7
3, 4
3
A + B
8
3, 4
3, 4
A + B
9
3, 4, 5
3
A + B
1)
Mono operation:The project is configured in SILworX for mono operation and has only
one processor module in slot 3, at least one system bus module in slot 1, I/O modules
and possibly communication modules. The switch for mono start-up must be set within
SILworX. It is always possible (and recommended!) to configure the system bus
modules redundantly!
Table 17: Slot Positions Recommended for Processor Modules
HIMA recommends to use variant 3 even if variant 1 would be possible. In doing so, the
processor module can be replaced without interrupting operation.
Since the operating system is designed to ensure maximum availability, other combinations
are possible, but not recommended. This allows HIMax to offer more flexibility, e.g., when
replacing modules or modifying the system. However, after such measures have been
completed, the system should be structured such that it corresponds to one of the
recommended variants noted in Table 17.
4.1.2
Mounting a Connector Board
Tools and utilities
Screwdriver, slotted 0.8 x 4.0 mm
Matching connector board
Summary of Contents for HIMax X-CPU 01
Page 1: ...X CPU 01 HIMax Manual...
