Hilti UW 10, Operating Instructions Manual

Page: 34 / 71

20
en
Drop 6 studs point first in the opposite chamber ends. If
the studs do not drop in completely press them with a
second stud. If necessary, clean the cartridge chamber
using a brush.
Take 6 cartridges (red or yellow, as required) out of the
packaging. To seal the cartridges in the chambers a thin
layer of Molycote 111 should be applied to their cir-
cumference.
Press 6 cartridges into the chambers until they are flush.
Put loaded revolving magazine (1) in semi-cylindrical
space in top of tool. Make sure the white marks are not
next to each other (transport safety).
Insert axle (7) as far as it will go. One repeating action
(backwards and forwards) will verify the correct func-
tioning of the tool.
Printed: 08.07.2013 | Doc-Nr: PUB / 5071291 / 000 / 01