Hilti TE 500-A36, Manual

Page: 14 / 164

10 English 2240497
*2240497*
8 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶
Always transport your products with the batteries removed!
▶
Remove the battery.
▶
Never transport batteries in bulk form (loose, unprotected).
▶
Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
9.1 Troubleshooting
Trouble or fault Possible cause Action to be taken
No hammering action. The product is too cold.
▶
Bring the product into contact
with the working surface, switch
it on and allow it to idle. If
necessary, repeat the procedure
until the hammering mechanism
begins to operate.
The battery runs down more
quickly than usual.
Battery condition is not optimal.
▶
Replace the battery.
The battery does not en-
gage with an audible "double
click".
The retaining lugs on the battery
are dirty.
▶
Clean the retaining lugs and refit
the battery.
Product switches off auto-
matically.
The overload protection system is
active.
The ON/OFF indicator flashes.
▶
Release the control switch.
Allow the product to cool down.
Press the control switch again.
Reduce the load on the tool.
The power tool or battery
gets very hot.
Electrical fault.
▶
Immediately switch off the
product. Remove the battery
and keep it under observation.
Allow it to cool down. Contact
Hilti service.
The product is overloaded (appli-
cation limit exceeded).
▶
Select a product that is suitable
for the intended purpose.
No response from the LEDs
on the battery.
The battery is not fully inserted.
▶
Push the battery in until it
engages with a double click.
The battery is discharged.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold.
▶
Bring the battery to the recom-
mended working temperature.