Hilti TE 500-A36, Manual

Page: 12 / 164

8 English 2240497
*2240497*
6.1.4 Fitting the side handle 2
CAUTION
Risk of injury! Loss of control over the breaker.
▶
Check that the side handle is fitted correctly and tightened securely.
1. Switch off the power tool.
2. Release the side handle clamping band by turning the handle grip.
3. Slide the side handle clamping band over the chuck from the front and into the recess provided.
4. Set the side handle to the desired position.
5. Tighten the side handle clamping band by turning the handle grip.
6.1.5 Setting the power level
After the battery is inserted, the product is always set by default to full power.
1. Press the "button for half power". The product runs at half power.
➥ The "half power indicator" lights up.
2. Press the "button for half power" again. The product runs at full power.
➥ The "half power indicator" goes out.
6.1.6 Inserting / removing the accessory tool 3
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶
Do not lay the hot accessory tool down on highly inflammable materials.
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶
Wear protective gloves when changing the tool.
The use of unsuitable grease can cause damage to the product. Use only genuine Hilti grease.
1. Apply a little grease to the connection end of the accessory tool.
➥ Use only genuine Hilti grease. Using the wrong grease can result in damage to the product.
2. Set the function selector switch to the “Chiseling” position .
3. Push the accessory tool into the chuck as far as it will go (until it engages).
4. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
➥ The product is ready for use.
5. Pull the chuck ring back as far as it will go and remove the accessory tool.
6.2 Types of work
CAUTION
Risk of injury! Loss of control over the breaker.
▶
Check that the side handle is fitted correctly and tightened securely.
Observe the safety instructions and warnings in this documentation and on the product.
6.3 Chisel positioning 4
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶
Do not operate the tool when the selector switch is set to “Chisel positioning”. Turn the function selector
switch until it engages in the “Chiseling” position.