Hilti TE 500-A36, Manual

Page: 10 / 164

6 English 2240497
*2240497*
3.3 Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which reduces vibration noticeably.
3.4 Service indicator
The product is equipped with a service indicator LED.
3.4.1 MMI
Status Meaning
The Service indicator lights up. Servicing is due.
The Service indicator flashes. Have the product repaired by Hilti Service.
The ON/OFF indicator lights up. The product is switched on
The ON/OFF indicator flashes. The product is switched off because of a transient
fault.
The ON/OFF indicator is off. The product is switched off.
The Half power indicator lights up. The product is working at half power.
The Half power indicator is off. The product is working at full power.
3.4.2 Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Li­ion
battery. The Li­ion battery state of charge is displayed after pressing one of the two battery release buttons.
Status Meaning
4 LEDs light. State of charge: 75 % to 100 %
3 LEDs light. State of charge: 50 % to 75 %
2 LEDs light. State of charge: 25 % to 50 %
1 LED lights. State of charge: 10 % to 25 %
1 LED blinks. State of charge: < 10 %
1 LED flashes, the product is not in working order. The battery has overheated or is completely dis-
charged.
4 LEDs flash, the product is not in working order. The power tool is overloaded or has overheated.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.5 Items supplied
Breaker, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group .
4 Technical data
TE 500-A36
Rated voltage
36 V
Weight in accordance with EPTA procedure 01 7.9 kg
Chuck TE­Y
Storage temperature
−20 ℃ … 70 ℃
Ambient temperature for operation −17 ℃ … 60 ℃
4.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a