![background image](http://html.mh-extra.com/html/hilti/te-300-avr/te-300-avr_original-operating-instructions_2135973016.webp)
10 English
401137
*401137*
7
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact
Hilti
Service.
Trouble or fault
Possible cause
Action to be taken
The breaker doesn’t
start.
Interruption in the elec-
tric supply.
▶
Plug in another electric
tool or appliance
and check whether it
works.
No hammering ac-
tion.
The power tool is too
cold.
▶
Bring the tip of the
accessory tool into
contact with the
working surface,
switch the power
tool on and allow it
to run. If necessary,
repeat the procedure
until the hammering
mechanism begins to
operate.
The breaker doesn’t
achieve full power.
The extension cord is
too long or its gauge is
inadequate.
▶
Use an extension cord
of an approved length
and/or of adequate
gauge.
The control switch is not
fully pressed.
▶
Press the control
switch as far as it will
go.
The chisel cannot
be released from the
chuck.
The chuck is not pulled
back fully.
▶
Pull the chuck back
as far as it will go and
remove the accessory
tool.
8
Disposal
Most of the materials from which
Hilti
tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to
Hilti
for recycling. Ask
Hilti
Service or your Hilti
representative for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as
household waste!
Summary of Contents for TE 300-AVR
