Hilti TE 2000-AVR, Manual

Page: 14 / 48

8 English 2154381
*2154381*
• Push the chisels into the holders provided until they engage securely.
• Take care to use only safe transport routes.
• Do not park the transport trolley on an incline.
7 Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet
can lead to severe injury and burns.
▶
Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries including
burns.
▶
Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group .
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 Troubleshooting table
Trouble or fault Possible cause Action to be taken
The power tool doesn’t start. Electronics initialization in progress
(takes up to 4 seconds after plug-
ging in).
▶
Switch the power tool off and
on again.
Interruption in the electric supply.
▶
Plug in another electric ap-
pliance and check whether it
works.
The supply cord or plug is defec-
tive.
▶
Have the parts checked by a
trained electrical specialist and
replaced if necessary.
Generator with sleep mode
▶
Apply a load to the generator
by connecting a second power
consumer (e.g. worklight). Then
switch the power tool on and off
again.
No hammering action. The power tool is too cold.
▶
Allow the power tool to warm
up to the minimum operating
temperature.