![background image](http://html.mh-extra.com/html/hilti/te-2000-avr/te-2000-avr_manual_2135960012.webp)
6
English
2154381
*2154381*
4.1.1 Using extension cords
WARNING
A damaged supply cord presents a hazard!
Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶
Check the appliance’s supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Recommended minimum conductor cross-section and maximum power-cord length for 120V supply
voltage
Cord
AWG 16
AWG 14
AWG 12
AWG 10
Conductor cross-section
1,31 mm²
2,08 mm²
3,31 mm²
5,26 mm²
Conductor cross-section
2,58 kcmil
4,11 kcmil
6,53 kcmil
10,4 kcmil
Cord length
25 m
30 m
50 m
100 m
Cord length
75 ft
100 ft
150 ft
250 ft
5
Operation
5.1
Preparations at the workplace
CAUTION
Risk of injury!
Inadvertent starting of the product.
▶
Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Connecting the supply cord to the power tool
The releasable plug connector may be connected to the product only when it is clean and dry and
when under no voltage (i.e. disconnected from the electric supply). The plug connector has a keyed fit.
1. Remove the supply cord from the cardboard box.
2. Plug the connector into the tool, pushing it in until it is heard to engage.
3. Plug the supply cord into the power outlet.
5.1.2 Fitting the accessory tool
1. Unplug the supply cord from the power outlet.
2. Lightly grease the connection end of the accessory tool.
➥ Use only the recommended grease supplied by
Hilti
. Using the wrong grease can result in damage
to the tool.
3. Push the accessory tool into the chuck as far as it will go, turning it and applying light pressure until it
engages with an audible click.
4. Check that the chisel has engaged correctly by gripping and pulling it.
5.1.3 Removing the accessory tool
CAUTION
Risk of injury!
The accessory tool may be hot and/or have sharp edges.
▶
Wear protective gloves when changing the accessory tool.
▶
Never lay down a hot accessory tool on a flammable surface.
1. Unplug the supply cord from the power outlet.
Summary of Contents for TE 2000-AVR
