19
en
Troubleshooting
Symptom
Possible cause
Possible solution
The tool doesn’t start
Fault in the electric power supply
Plug in another electric tool and check
whether it starts
Defective supply cord or plug
Have it checked by an electrical
specialist and replace if necessary
Switch defective
Have it checked by an electrical
specialist and replace if necessary
No hammering action
The tool is too cold
Allow tool to reach the minimum
operating temperature
See section “Before use”
Function selection switch
Set function selection switch to
set to rotary drilling
hammer drilling
Tool doesn’t produce full
Cross-section of the
Use an extension cord of adequate cross-
power
extension cord is inadequate
sectional area. See section “Before use”
Control switch is not pressed fully
Press the control switch as far as it will go
Function selection switch set
Set function selection switch
to precision hammering action
to hammer drilling
Forwards / reverse switch set
Set forwards / reverse switch
to reserve when drilling
to forwards
Drill bit cannot be released
Chuck not opened fully
Pull the chuck locking sleeve back as
far as it will go and remove the insert
tool
EC declaration of conformity (original)
Description:
Rotary Hammer
Designation:
TE 2 / TE 2-E / TE 2-S / TE 2-M
Year of design:
2005
Hilti Corporation
, Feldkircherstrasse 100,
FL-9494 Schaan
Paolo Luccini
Jan Doongaji
Head of BA
Senior Vice President
Quality and Process Management
BU Drilling & Demolition
Business Area
Electric Tools & Accessories
01/2012
01/2012
We declare, under our sole responsibility, that this product
complies with the following directives and standards:
2004/108/EC, 2006/42/EC, EN 60745-1, EN 60745-2-6,
EN 12100, 2011/65/EU
Technical documentation filed at:
Hilti Entwicklungsgesellschaft mbH
Zulassung Elektrowerkzeuge
Hiltistrasse 6
86916 Kaufering
Deutschland
02_BA_TE2_S_M_P1_en.qxd:02_BA_TE2_S_M_P1_en.qxd 29.9.2012 9:53 Uhr Seite 19
Printed: 14.02.2014 | Doc-Nr: PUB / 5170540 / 000 / 00