![background image](http://html1.mh-extra.com/html/hilti/sr-4-22/sr-4-22_manual_2136409015.webp)
*2243481*
2243481
English
11
Storage
WARNING
Accidental damage caused by defective or leaking batteries
!
▶
Always store your products with the batteries removed!
▶
Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶
Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9
Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed
Status indicators of the Liion battery
.
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact
Hilti
Service.
Trouble or fault
Possible cause
Action to be taken
The battery runs down more
quickly than usual.
Battery condition is not optimal.
▶
Call up the battery’s state of
health. → page 6
The battery does not engage
with an audible click.
The retaining lugs on the battery
are dirty.
▶
Clean the retaining lug and refit
the battery.
The LEDs do not light up.
The battery is not fully inserted.
▶
Push the battery in until it
engages with an audible click.
Battery defective.
▶
Contact
Hilti
Service.
The saw blade cannot be
removed from the chuck.
The locking lever was not pushed
as far as it will go.
▶
Turn the locking lever as far as
it will go and remove the saw
blade.
Blade holder clogged by residues
from sawing operations.
▶
Remove the residues from
sawing operations and regularly
clean the blade holder from the
outside. Care of the product.
Product does not develop full
power.
The control switch is not fully
pressed.
▶
Press the control switch fully.
The battery is discharged.
▶
Change the battery and charge
the empty battery.
The saw blade cannot be
removed from the chuck.
The locking sleeve is not turned as
far as it will go.
▶
Turn the locking sleeve as far as
it will go and remove the saw
blade.
10
Disposal
WARNING
Risk of injury due to incorrect disposal!
Health hazards due to escaping gases or liquids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your
Hilti Store
, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which
Hilti
products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to
Hilti
for recycling. Ask
Hilti
Service or your Hilti sales representative for further information.
Summary of Contents for SR 4-22
