Hilti SFL 14-A, Operating Instructions Manual, Page: 8 / 16

6 English
@
Reflector
;
Lamp body
=
Control knob
%
On/off switch
&
Strap attachment point
(
Battery
3.2 Intended use
The product described is a cordless lamp. It is designed to be used to illuminate areas of jobsites. Use the
product in a dry environment only.
▶
Use this product only with Hilti Li­ion batteries of the B 14, B 22 and B 36 series.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Items supplied
Cordless lamp, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Center or online
at: www.hilti.com
3.4 State of charge display
The charge state of the Li­ion battery is displayed after pressing one of the two battery release buttons lightly
(press only until slight resistance is felt).
Status Meaning
4 LEDs light. • Charge state: 75 % to 100 %
3 LEDs light. • Charge state: 50 % to 75 %
2 LEDs light. • Charge state: 25 % to 50 %
1 LED lights. • Charge state: 10 % to 25 %
1 LED blinks. • Charge state: < 10 %
Note
If the battery charge state LEDs blink, please refer to the information given in the Troubleshooting
section.
4 Technical data
SFL 14­A SFL 22­A SFL 36­A
Voltage 14.4 V 21.6 V 36.0 V
5 Operation
5.1 Inserting the battery
CAUTION
Electrical hazard. Dirty contacts may cause a short circuit.
▶
Before inserting the battery, check to ensure that the battery terminals and the contacts on the
product are free from foreign objects.
CAUTION
Risk of injury. If the battery is not fitted correctly it may drop out and fall.
▶ Check that the battery is securely seated in the product so that it cannot drop out and fall, thereby
presenting a hazard to other persons.
▶
Fit the battery and check that the battery is securely seated in the appliance.
Printed: 26.10.2016 | Doc-Nr: PUB / 5140725 / 000 / 07