Hilti NURON GDG 6-22, Original Operating Instructions, Page: 30 / 468

26 English 2327660
*2327660*
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
▶
The motor runs.
3. Lock the on/off switch.
6.2 Types of work 3
1. Switch the tool on. → page 26
2. By turning the adjusting knob for speed, set a speed that is suitable for the accessory tool and the
planned use.
3. Use only the intended working face of the accessory tool. Example: Never try to use the flat side of an
abrasive cut-off wheel for grinding. Abrasive cut-off wheels are intended for cutting at their peripheral
edge.
4. Secure the workpiece. Never try work with a small workpiece held in one hand and the die grinder held
in the other. Always hold the die grinder with both hands on the grips provided.
5. Guide the die grinder to the workpiece. Apply moderate pressure and do not press the accessory tool
into the material.
6.3 Switching off
▶
Press the rear section of the on/off switch.
▶
The on/off switch jumps into the off position and the motor stops.
7 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶
Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Li­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.