Hilti NPR 032 PE-A22, Operating Instructions Manual

Page: 18 / 22

14 English
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group .
7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶
Always transport your products with the batteries removed!
▶
Remove the battery.
▶
Never transport batteries in bulk form (loose, unprotected).
▶
Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 The crimping / pressing tool is not in working order
Malfunction Possible cause Action to be taken
The LEDs on the battery indi-
cate nothing.
The battery is not correctly in-
serted.
▶
Push the battery in until it
engages with a double click.
The battery is discharged.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold.
▶
Allow the battery to cool
down or to warm up to room
temperature.
1 LED on the battery flashes. The battery is discharged.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold.
▶
Allow the battery to cool
down or to warm up to room
temperature.
4 LEDs on the battery flash. Product momentarily overloaded.
▶
Allow the product to cool down.
Red LED => lights continu-
ously and a warning tone is
emitted.
Technical problem.
▶
Incorrect operation is possible!
Contact Hilti Service.
Red LED => flashes at short
intervals and a warning tone
is emitted.
The state of charge of the battery
is too low to allow a complete op-
erating cycle.
▶
Change the battery and charge
the empty battery.
Red LED => lights briefly and
no warning tone is emitted.
Product overheated.
▶
Allow the product to cool down.
Printed: 29.10.2018 | Doc-Nr: PUB / 5436899 / 000 / 01