Hilti NPR 032 IE-A22, Manual

Page: 12 / 72

8 English 2207116
*2207116*
In order to ensure correct pressing and to ensure that the tool functions reliably and safely, only the
pressing ring approved by the system manufacturer / tool manufacturer for use with the tool may be
used.
1. Remove the battery.
2. Press the locking pins.
3. Rotate the locking pins counterclockwise as far as they will go.
4. Pull out the locking pins.
5. Fit the adapter jaws.
6. Push the locking pins in until they engage.
7. Bring the pressing ring into position on the fitting to be pressed.
8. Close the pressing ring.
5.8 Removing the pressing ring and adapter jaws
WARNING
Risk of injury! Unintentional starting.
▶
Remove the battery before fitting, changing or removing the crimping / pressing jaws.
1. Open the pressing ring.
2. Remove the pressing ring.
3. Remove the battery.
4. Press the locking pins.
5. Rotate the locking pins counterclockwise as far as they will go.
6. Pull out the locking pins.
7. Work the adapter jaws forward and out of the product.
5.9 Assemble Hilti retaining leash (optional) 4
ATTENTION
Damage to the product and / or the retaining leash. Incorrect handling can result in damage to the
product and/or retaining leash.
▶ Do not use a metal chain as a retaining leash. Do not use retaining leashes longer than 6 ft (2 m).
To avoid damage and injury, when working at a height it is advisable to use the Hilti retaining strap.
The retaining strap allows a securing cord or leash to be attached.
When working with the product, you must comply with national regulations for working at heights.
1. Remove the battery.
2. Insert the two tabs on the retaining leash into the slots on each side of the base.
3. Secure the retaining leash with the screws supplied.
4. Refit the battery.
5.10 Dismantle the Hilti retaining leash (optional) 4
1. Remove the battery.
2. Remove the two retaining strap securing screws.
3. Pull the two retaining strap tabs out of the slots in the base and remove the retaining strap.
4. Refit the battery.