Hilti GTB 6X-A22, Original Operating Instructions, Page: 22 / 204

16 English 2241319
*2241319*
3 Description
3.1 Overview of the product 1
@
Abrasive belt
;
Swing arm
=
Hand guard
%
Side handle
&
Guide roller
(
Lockable on/off switch
)
Adjusting knob for speed
+
Battery release button
§
Battery
/
Dust filter
:
Guard
∙
Drive roller
$
Working range
£
Relay roller
3.2 Intended use
The product described is a hand-held, cordless pipe belt grinder. It is designed for grinding and polishing
metal pipes and round-section bar stock, without use of water.
▶
Use only Hilti Li­ion batteries of the B 22 series with this product.
▶
Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Possible misuse
Do not use the product for wet grinding.
Do not use the product to work on hazardous or flammable materials (e.g. asbestos, magnesium, wood).
3.4 Items supplied
Pipe belt grinder, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group
3.5 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the power tool’s performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
3.6 Li-ion battery charge status display
The charge status of the Li­ion battery is displayed after one of the two battery release buttons is pressed.
Status Meaning
4 LEDs light. Charge status: 75 % to 100 %
3 LEDs light. Charge status: 50 % to 75 %
2 LEDs light. Charge status: 25 % to 50 %
1 LED lights up. Charge status: 10 % to 25 %
1 LED flashes. Charge status: < 10 %