ORIGINAL OPERATING INSTRUCTIONS
DX 76 PTR powder-actuated fastening tool
It is essential that the operating instructions
are read before the tool is operated for the
first time.
Always keep these operating instructions to-
gether with the tool.
Ensure that the operating instructions are
with the tool when it is given to other persons.
Contents
Page
1 Safety instructions
18
2 General information
20
3 Description
21
4 Accessories, consumables
23
5 Technical data
23
6 Before use
23
7 Operation
24
8 Care and maintenance
27
9 Troubleshooting
29
10 Disposal
32
11 Manufacturer’s warranty - tools
32
12 EC declaration of conformity (original)
33
13 Confirmation of CIP testing
33
14 Health and safety of the operator
33
1
These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cover
pages. Keep these pages open while studying the oper-
ating instructions.
In these operating instructions, the designation “the tool”
always refers to the DX 76 PTR powder-actuated fasten-
ing tool.
Parts and operating controls
1
DX 76 PTR tool
@
MX 76‑PTR fastener magazine
;
Contact pins
=
Protective cap
%
Cycling grip
&
Cartridge strip guideway
(
Loading status control window
)
Power regulation wheel
+
Power regulation indicator
§
Padded end cap
/
Tool casing
:
Grip pad
·
Trigger
$
Piston guide release lever
£
Piston guide
|
Fastener magazine spall guard
¡
Fastener stop piece
Q
Ventilation slots
W
X‑76‑F‑15‑PTR fastener guide
E
Tool spall guard
Wearing parts
R
X‑76‑P‑ENP‑PTR piston
T
X‑76‑P‑ENP2K‑PTR piston
Z
X‑76‑P-PB-PTR piston brake
1 Safety instructions
1.1 Basic information concerning safety
In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.
1.1.1 Using cartridges
Use only Hilti cartridges or cartridges of equivalent
quality.
Use of cartridges of inferior quality in Hilti tools may lead
to a build-up of unburned powder, which may explode
and cause sever injuries to operators and bystanders.
Cartridges must fulfill one of the following minimum re-
quirements:
a) The applicable manufacturer must be able to verify
successful testing in accordance with the EU stand-
ard EN 16264
or
b) The cartridges must bear the CE conformity mark
(mandatory in the EU as of July 2013).
NOTE
All Hilti cartridges for powder-actuated tools have been
tested successfully in accordance with EN 16264. The
tests defined in the EN 16264 standard are system tests
carried out by the certification authority using specific
combinations of cartridges and tools. The tool designa-
tion, the name of the certification authority and the system
test number are printed on the cartridge packaging.
Please refer to the packaging example at:
www.hilti.com/dx-cartridges
1.1.2 Personal safety
a)
Stay alert, watch what you are doing and use
common sense when operating a direct fastening
tool. Do not use tool while tired or under the influ-
ence of drugs, alcohol or medication.
A moment of
inattention while operating tools may result in serious
personal injury.
en
18
Printed: 30.05.2016 | Doc-Nr: PUB / 5069849 / 000 / 04
